![]() you do not need to add that much solder, since the 3 legs are very close together. Once it is done, be extra careful about your movements and where you place each element (driver, PCB, rest of the headset), since there is now 5 thin wires to watch. to have a better access to the PCB (to solder the 3 legs R-, L, G), you might need to remove the 4 tiny screws holding the PCB to the plastic housing. Do not panic, it is simply located at the top of the housing in a tiny hole: it prevents the earcup from hitting/grinding against the earcup bracket. when separating the driver and the housing, a small rubber bumper might fall off. The wire between the driver and the PCB is rather short and thin, so it might break if you are not careful and methodical in how you place each element on your table. ![]() once the driver is ready to be removed from the earcup plastic housing, do it gently and do not pull it away. as seen on the first picture, there is 4 small screw (blue circles) and 1 smaller crew (red circle) for the driver assembly. to remove the earpads, simply pull on them while holding them closer to the plastic housing.
0 Comments
Leave a Reply. |